Packet capture shows the details of the packets that pass through an interface. I get the %Invalid interface type and number error. An active show command that decodes and displays packets from a. %LINK-5-CHANGED: Interface Vlan1, changed state to up End with CNTL/Z.Ĭorp(config-if)#description myDescriptionIsAwesome1Ĭorp(config-if)#ip address 10.1.1.1 255.255.255.0Ĭorp(config-if)#description myDescriptionIsAwesome2Ĭorp(config-if)#description myDescriptionIsAwesome3 book exampleĮnter configuration commands, one per line. Here is the section in the book and next is my implementation and the error I am getting. I have applied the network as is in the book inside my Packet Tracer. I am trying to apply a scenario from the Cisco CCENT book where a 2811 Router uses VLANs.
